UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
1998nM2 engine noise https://ukbeg.com/forum/viewtopic.php?f=8&t=24756 |
Page 1 of 2 |
Author: | stevered [ 14 Feb 2021 09:27 ] |
Post subject: | 1998nM2 engine noise |
My M2 has started making what I can only describe as a noise like a squealing fanbelt it comes and goes at tick over/low revs got oil pressure and can see the oil returning to the oil tank plenty of oil in gearbox/primary starts up fine ticks over lovely then maybe after a minute or so will start squealing then it will go away as suddenly cant tell where its coming from have been round the engine with a screwdriver to my ear cant tell this is happening in neutral not been brave enough to ride it Any ideas I posted this on the FB page and was advised to to check fanbelt tension LOL TIA Steve |
Author: | stevered [ 14 Feb 2021 10:24 ] |
Post subject: | Re: 1998 M2 engine noise |
Weirder just run it for 10 mins this morning no noise I am going to go ride it see what happens Steve |
Author: | stevered [ 14 Feb 2021 14:05 ] |
Post subject: | Re: 1998nM2 engine noise |
went for ride couple miles no noise couple hours later went out again after a mile or so its squealing again then it stopped in gear out of gear, clutch in or out no difference so its crank or primary related TIA Steve |
Author: | Nutah [ 14 Feb 2021 18:14 ] |
Post subject: | Re: 1998nM2 engine noise |
![]() is it the primary chain tensioner ![]() |
Author: | 03 [ 14 Feb 2021 18:35 ] |
Post subject: | Re: 1998nM2 engine noise |
Nutah wrote: :askmaz: is it the primary chain tensioner ![]() The question is for a 98 bike, has the uprated tensioner ever been fitted? If not, it is highly likely to have cracked. Very common issue indeed before the tensioner was significantly strengthened. |
Author: | Adam [ 15 Feb 2021 12:02 ] |
Post subject: | Re: 1998nM2 engine noise |
Steve is correct with his warning about the tensioner. The only one I've ever seen that wasn't broken in an early bike, was the one I fished out of one of mine ![]() |
Author: | gusm2 [ 15 Feb 2021 18:54 ] |
Post subject: | Re: 1998nM2 engine noise |
The oil is red ?, I'd consider replacing it with HD Sport Trans ![]() ![]() |
Author: | Nutah [ 16 Feb 2021 07:09 ] |
Post subject: | Re: 1998nM2 engine noise |
if you look close at the picture Gus it's broken on the right hand end & as Steve said it was so slack , may be why it broke the end off but lucky he found it before it did more damage ![]() |
Author: | Nutah [ 16 Feb 2021 07:11 ] |
Post subject: | Re: 1998nM2 engine noise |
Nutah wrote: :askmaz: is it the primary chain tensioner ![]() do i win a goldfish ![]() |
Author: | gusm2 [ 16 Feb 2021 07:51 ] |
Post subject: | Re: 1998nM2 engine noise |
Nutah wrote: if you look close at the picture Gus it's broken on the right hand end & as Steve said it was so slack , may be why it broke the end off but lucky he found it before it did more damage ![]() ![]() |
Author: | stevered [ 16 Feb 2021 08:12 ] |
Post subject: | Re: 1998nM2 engine noise |
Thanks for all your help guys hopefully going to find out if the noise has gone today Steve |
Author: | Nutah [ 16 Feb 2021 09:12 ] |
Post subject: | Re: 1998nM2 engine noise |
![]() |
Author: | Bonzo [ 16 Feb 2021 13:18 ] |
Post subject: | Re: 1998nM2 engine noise |
Nutah wrote: Nutah wrote: :askmaz: is it the primary chain tensioner ![]() do i win a goldfish ![]() Yes, Maz will despatch one by post forthwith. |
Author: | barney [ 16 Feb 2021 13:25 ] |
Post subject: | Re: 1998nM2 engine noise |
Bonzo wrote: Nutah wrote: Nutah wrote: :askmaz: is it the primary chain tensioner ![]() do i win a goldfish ![]() Yes, Maz will despatch one by post forthwith. ![]() |
Page 1 of 2 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |