Click on the link , then scroll to the last post , it explains how to read them using a shorting link
viewtopic.php?f=17&t=807
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| poor running https://ukbeg.com/forum/viewtopic.php?f=8&t=24884 |
Page 1 of 4 |
| Author: | barney66 [ 19 Jun 2021 17:33 ] |
| Post subject: | poor running |
Hi all, I’m after a little knowledge and help please, Took 2003 XB9s for mot last week only a mile away passed with a little warning on missing pillion pegs, on the way seemed a bit hesitant, thought it might be due to swapping debaffled exhaust to standard for mot, swapped it back after and went for 30 mile round trip Today. Gave it a bit of stick on the way, pulled up on the way back for a phone call and idle was a bit rough came back into 40 zone and running really rough and management light came on and stopped coasted into bus stop checked battery voltage ok, and for any loose leads found nothing then after 20 min started and set off again seemed to do a small backfire a couple of times and as I accelerated engine light would flash on then off,as I came back into 60 opened it up and over 3000rpm backfired light came on shut off throttle and it went off like in limp mode maybe, anyway got home plenty of fresh fuel clean air filter new Oils 1000 mile on plugs and bike has under 7000 mile on it, any ideas please? sorry got no cable or software for plugging in, Thanks for reading |
|
| Author: | Maz [ 19 Jun 2021 19:17 ] |
| Post subject: | Re: poor running |
You don't need software/cable to read TC's.....see the how to section. |
|
| Author: | Nutah [ 19 Jun 2021 19:17 ] |
| Post subject: | Re: poor running |
| Click on the link , then scroll to the last post , it explains how to read them using a shorting link viewtopic.php?f=17&t=807
|
|
| Author: | barney66 [ 19 Jun 2021 19:54 ] |
| Post subject: | Re: poor running |
Ok Thank you both very much for the replies, I have just done this and can’t quite determine the flashes do you count light on or off ? either way I thought it was 66 but no code for 66, I’m hoping it’s not 55 and ecm f**cked Thanks barney |
|
| Author: | Maz [ 19 Jun 2021 20:22 ] |
| Post subject: | Re: poor running |
Ignore the 6 rapid flashes, that's the interval.....count lights on for 1 second and be careful to note the 2 second interval in between the 1st and second digit. |
|
| Author: | barney66 [ 20 Jun 2021 07:27 ] |
| Post subject: | Re: poor running |
Maz wrote: Ignore the 6 rapid flashes, that's the interval.....count lights on for 1 second and be careful to note the 2 second interval in between the 1st and second digit. Ok great, after looking again it’s 15 air temp sensor, I have cleaned it carefully with brake cleaner and gently dry with comp air and still shows the same, can I clear this code first then plug in and try again, if not any ideas where to get one from in Uk please, Thanks for all your help |
|
| Author: | Nutah [ 20 Jun 2021 20:01 ] |
| Post subject: | Re: poor running |
Riders of Bristol ask for UKBEG discount 13%
|
|
| Author: | Maz [ 20 Jun 2021 22:17 ] |
| Post subject: | Re: poor running |
I have them in stock but you'd have to collect 
|
|
| Author: | barney66 [ 21 Jun 2021 17:17 ] |
| Post subject: | Re: poor running |
Thanks both for the reply, riders of Bristol haven’t got them and can’t get them |
|
| Author: | barney66 [ 21 Jun 2021 17:19 ] |
| Post subject: | Re: poor running |
Maz wrote: I have them in stock but you'd have to collect Thanks Maz, could you post please or not ? Thanks barney |
|
| Author: | barney [ 21 Jun 2021 22:02 ] |
| Post subject: | Re: poor running |
barney66 wrote: Maz wrote: I have them in stock but you'd have to collect Thanks Maz, could you post please or not ? Thanks barney I think COLLECT is the key word here . |
|
| Author: | Maz [ 21 Jun 2021 22:39 ] |
| Post subject: | Re: poor running |
Correct...and I'd be amazed if the IATS was the cause of your running issues, it has very little bearing on fueling ! |
|
| Author: | barney66 [ 22 Jun 2021 05:16 ] |
| Post subject: | Re: poor running |
Maz wrote: Correct...and I'd be amazed if the IATS was the cause of your running issues, it has very little bearing on fueling ! Thanks for the reply, I understand you haven’t seen the bike so not asking for a diagnostic, but any other ideas what else it could be please or where else to look, this was the only code that showed up ? Also anybody know anywhere else I could get this sensor from, I will change it anyway as it comes up faulty, but need it mail order ? Thanks all |
|
| Author: | barney66 [ 23 Jun 2021 18:35 ] |
| Post subject: | Re: poor running |
Ok, little update on bike, tried cleaning intake air temp sensor then measured resistance on it warmed it with heat gun and the resistance changed,( can’t remember the figures ) took fuel line off to check pump and squirts plenty of fuel out,put it back together and run it on bike table warmed it up and then open throttle a couple of times to 4000rpm briefly and light came on again. Codes now say 13 & 15 so 02 sensor as well now, is there something else going on or can one cause the other ? I haven’t cleared the Iat code as I have no means other than the 50 on off cycles, any help or advice is much appreciated, don’t mind buying a cable if I need Thanks barney |
|
| Author: | Nutah [ 23 Jun 2021 20:07 ] |
| Post subject: | Re: poor running |
Pash may have a cable for sale give him a pm on this site , as he understands the ecm milarky |
|
| Page 1 of 4 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|