| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| Gear selector pivot bolt S1 / X1 https://ukbeg.com/forum/viewtopic.php?f=8&t=2612 |
Page 1 of 1 |
| Author: | gaz [ 15 Sep 2009 00:15 ] |
| Post subject: | Gear selector pivot bolt S1 / X1 |
I have solved the previous gear shifter problem with the help on here and chatting with Pash. The S1 has had an X1 Primary cover fitted, I think. The pivot bolt on the gear lever, which passes through the cover is working itself loose. I know that I have to spend probably just as much time tightening bolts as riding but this one is a real pain. Has anyone got a close up picture or schematic of the bolt, lever and spacers so that I can check that it’s correct. A torque setting and what Loctite, I'm using stud-lock but possibly no tightening the bolt enough, thin line between tight and snapped. |
|
| Author: | gusm2 [ 18 Sep 2009 17:12 ] |
| Post subject: | Re: Gear selector pivot bolt S1 / X1 |
Mine was a pain in the arse to begin with as well when I put the later linkage on in place of the early contraption, make sure the hole is oil free and I used Loctite 222 threadlocker, touch wood its been ok since,good luck |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|