after reading all the fun people are having with the quill cans i taking it off the missis
( shineyshoes) bike .
can anyone give a step by step cut and shut guide to the mod as im sitting with grinder poised ready and willing
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| tubbs exhaust mod https://ukbeg.com/forum/viewtopic.php?f=8&t=486 |
Page 1 of 1 |
| Author: | chris_sheena [ 19 May 2009 18:29 ] |
| Post subject: | tubbs exhaust mod |
after reading all the fun people are having with the quill cans i taking it off the missis ( shineyshoes) bike . can anyone give a step by step cut and shut guide to the mod as im sitting with grinder poised ready and willing
|
|
| Author: | tubbs [ 19 May 2009 21:21 ] |
| Post subject: | Re: tubbs exhaust mod |
mr_stabby wrote: after reading all the fun people are having with the quill cans i taking it off the missis not my mod if you do it.( shineyshoes) bike . can anyone give a step by step cut and shut guide to the mod as im sitting with grinder poised ready and willing should read "how/and were to cut my pipe" |
|
| Author: | Lands End [ 19 May 2009 23:09 ] |
| Post subject: | Re: tubbs exhaust mod |
Some for you: http://www.youtube.com/watch?v=7ivdn7eno04 http://www.youtube.com/watch?v=CevPgQOHZ7Y http://www.youtube.com/watch?v=fi860nK-lK4&feature=related |
|
| Author: | mcrbuelligan [ 21 May 2009 21:11 ] |
| Post subject: | Re: tubbs exhaust mod |
http://www.youtube.com/watch?v=07Vfc0Ph ... re=related what can is on this ???? |
|
| Author: | softley [ 22 May 2009 18:49 ] |
| Post subject: | Re: tubbs exhaust mod |
one cut around the rear weld. weld a slide hammer head to the internals and pull them out. remove everything from between the baffle plates and replace with 2" perferated tubing that will run from the incoming tube to the back of the box. postion the baffles so when slid back in they align with the jack points (i welded the baffles to the perf pipe and filled in other holes). slide them and the tube back in packing between the plates with Stainless wool. weld back end back on. Before anyone asks i did not take pictures |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|