Cheers Nick, i'll give that a go next week when i'm off work.
I never had to do that before, i'm sure it was just plug & play
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| ECM Spy COM ports https://ukbeg.com/forum/viewtopic.php?f=8&t=5513 |
Page 1 of 1 |
| Author: | zoidberg [ 16 Mar 2010 01:53 ] |
| Post subject: | ECM Spy COM ports |
I tried to connect the laptop to the bike yesterday (MY07XBSs) and it would not communicate, I had to reinstall the software a while ago after formatting the HDD in my laptop and haven't used it since. Are there any drivers for the lead for vista, i can't remember needing them before but it's requesting them now. it would only look at COM:3 even through the autodetect function. any ideas?? Cheers.... |
|
| Author: | pash [ 16 Mar 2010 06:01 ] |
| Post subject: | Re: ECM Spy COM ports |
Drivers are here: http://www.ftdichip.com/Drivers/CDM/CDM20600.exe Go to your Device Manager and make sure that when you plug your lead in, you see it appear in the "Ports (COM and LPT)". Then, make a note of the COM port number assigned to it. If it is high, like 23 or something, then it is better to right click on it, click properties, then click on the port settings tab, then advanced and then force it to use a lower COM port number. This COM port number may be being used by a mouse or something, or something that connected to your computer once, but take a risk.... The worst that will happen is a yellow triangle will appear on your device manager. Anyway, when done, try ECMSpy again with Autodetect or force it to use the COM port you have just set. Have a look here too - viewtopic.php?f=8&t=5196 Good luck |
|
| Author: | zoidberg [ 16 Mar 2010 06:23 ] |
| Post subject: | Re: ECM Spy COM ports |
Cheers Nick, i'll give that a go next week when i'm off work. I never had to do that before, i'm sure it was just plug & play
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|