I need to know the ring gap for a 250 (mid 80's) Bultaco Sherpa. If no one knows, is there a general rule of thumb of gap according to diameter of piston
I thank you Gents
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| Stink wheel expert needed https://ukbeg.com/forum/viewtopic.php?f=8&t=9255 |
Page 1 of 1 |
| Author: | Adam [ 04 Dec 2010 18:36 ] |
| Post subject: | Stink wheel expert needed |
I need to know the ring gap for a 250 (mid 80's) Bultaco Sherpa. If no one knows, is there a general rule of thumb of gap according to diameter of piston I thank you Gents
|
|
| Author: | kevmean [ 04 Dec 2010 18:42 ] |
| Post subject: | Re: Stink wheel expert needed |
Adam wrote: is there a general rule of thumb of gap according to diameter of piston Yep 
|
|
| Author: | kevmean [ 04 Dec 2010 18:45 ] |
| Post subject: | Re: Stink wheel expert needed |
http://www.thumpertalk.com/forum/archiv ... 56232.html
|
|
| Author: | kevmean [ 04 Dec 2010 19:14 ] |
| Post subject: | Re: Stink wheel expert needed |
http://www.rcuniverse.com/forum/m_8315757/printable.htm |
|
| Author: | Adam [ 04 Dec 2010 20:01 ] |
| Post subject: | Re: Stink wheel expert needed |
Cheers Kev. Used the same ratio when I machined a Golf Diesel piston for a 4 stroke bike. I've spent an amusing afternoon plugging the crankpin and padding the cases 
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|