Hi all, what should the % reading be when I turn the ignition on in Diag mode? Mine is currently showing 2% ?

If somebody could remind me how to get into diagnostic mode then I will go and check mine ...

Have you done a TPS reset?

_________________
08 Specialized Langster

is that done like this? twist the throttle 3 times - keep the throttle fully open for one second and fully closed for one second

I'll give it a go and see what happens!

hold both buttons on the cluster down and turn ignition on!

OK I have to ask, what is TPS?

Throttle Position Sensor

_________________
Feros Ferio

My wrist has one of those, it shuts off the fuel after about 10mm of twist

_________________
"With square conduct, level steps, and upright intentions ..”

_________________
IF IT BLEEDS WE CAN KILL IT ,THIS STUFF WILL MAKE YOU A GODDAM SEXUAL TYRANASURUS ,YOUVE BEEN PUSHING TOO MANY PENCILS DILLON .GET TO THE CHOPPER

ok, so I took the bike in to be scanned as I couldn't get the TPS to read zero. they did a TPS reset but as soon as I got home and checked it I got a reading of 2% again?! I have also noticed that I've lost the engine braking as it's fueling with the throttle closed? anyone got any ideas?

Did they update the firmware too?

_________________
08 Specialized Langster

Just got round to checking my CR - it's 2.0% as well

Is it 2.0% or 2 volts ?

I need to dig out the manuals ....

Don't think so Pash.

2% Gordon.

Any ideas on why it's lost the engine braking it used to have?

AFAIK IAC position is mirrored in TP (for fuel metering), so it will never be zero.
As I understand it. I don't have such newfangled kinckknack, so I might be wrong.

_________________
"It is often said that before you die your life passes before your eyes. It is in fact true. It's called living."
Terry Pratchett