http://www.ebay.co.uk/itm/130665087885? ... 1423.l2649

Doesn't appear to be attracting many bids...

_________________
08 Specialized Langster

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

I was looking at that, but how do you know what it's been flashed for ?

Good question. I would give Pinwall a call and get them to read the sticker off for you then I would call Mike at EBR and ask what the config was for. Alternatively, ask Pinwall what pipe was fitted to the bike (you may even see it in their other listings).

_________________
08 Specialized Langster

I am guessing it goes with this exhaust:

http://www.ebay.co.uk/itm/08-Buell-1125 ... 1e6c3f0062

No clue what it is though...

_________________
08 Specialized Langster

its a keda, d_adams off badweb
no where near as good s mine though
they don't list the ecm numbers on ebr anymore so as you say you'll have to ask them to double check, but chances are its for that pipe
good call pash, i ended up buying a new ic for my 1125 after looking through the rest of pinwalls stuff which then lead me to another breaker in the states.
i've had stuff from pinwall before with no probs, although i had it delivered to the usa

_________________
Buell X1
Buell xb12s
Buell 1125r
Ebr 1190rx
Bimota Db7
Norton v4rr??



http://www.aph-performance-engineering.com

It went for $200 plus unknown postage. And you woudl have to send to EBR to have it flashed (unless you happen to own that exhaust) - at a good cost no doubt

you can get a brand new one flashed for your exhaust for $300 (plus $50 postage) direct from EBR.

I'm after one but that isn't enough of a saving for me