Hi guys,

I have EcmSpy and the cable and help is needed to remap, is anyone around London that can help me?

cos I don't want to mess up everything

any help is appreciate.

Your not many miles from me,
Do you want to just do a TPS reset? then yes i can,
but the mapping side is a no no from me.

Hi, I'm off on Wednesday, are you free?
you can pm me ..

Cheers,

Roberto

You can text me your tel and address, I'll pop there

Cheers.

PM for ya

Managed to reset the TPS after unfreeing a seized throttle stop screw which took most of the time,
Hows the bike running now Slimboy?

Hey mr waff,
Sorry for my late response, but I was so busy this Christmas, I just log in today.

Thanks for your help.
When the engine is hot and I close the throttle the bike stays accelerated and after few seconds go to normal.

PS: Did you enjoy the wine?

Enjoyed drinking the wine Slimboy.
Re: the revs when engine's warm, just wind back the throttle stop screw a fraction that should cure it,had the same problem when i done my first reset.

Hanging idle is commonly caused by too much spark advance at closed throttle and rpm just above idle speed.
Reduce spark advance and the issue will disappear.

_________________
"It is often said that before you die your life passes before your eyes. It is in fact true. It's called living."
Terry Pratchett

Gunter
This issue happens when the engine is fully warmed up not when cold,
How do i reduce the spark advance (in simple terms please)appreciate the feedback.

usual procedure: click cell, punch in new number, click "=", burn, done.

_________________
"It is often said that before you die your life passes before your eyes. It is in fact true. It's called living."
Terry Pratchett

Thanks guys for the suggestions