Very much so

_________________
08 Specialized Langster

The new machine ! Hope I havent bitten off more than I can chew

Merry Christmas

Thats better!

Finally got a chance to take power commander off , a pretty poor job was done on the fitting in the first place, one thing I'm stuck on is the O2 sensor, the original is a single round connector on the harness but the one coming from exhaust is a 4 prong, any one seen this before? Do I need to replace the 02 sensor? Thanks, will try get a photo up of what I mean.

Also what fuel map should do run and where do I get one? Has force winder and Vance and Hines

The four wires will be two for the heater, one for ground and one for output.

If you want to keep that one, connect one heater and the ground to... Wait for it... Ground... The other heater to a switched 12V supply (orange and white wire maybe) and the output to the single input on the loom.

The proper ones can be had for a tenner or so on eBay brand new from the states from time to time.

_________________
08 Specialized Langster