I will be removing mine of the bike tommorow,I think it has a few minor scuffs on it and a new spring £90 if your interested,I will post a pic when I remove it.As to why I am removing it well the bike goes on Monday.

Bri, why would you want to remove yours ... just out of interest ...

_________________
"With square conduct, level steps, and upright intentions ..”

See above.............

How much do you want for it and why are you getting rid of the bike?

_________________
08 Specialized Langster

me please - pending pics

_________________
"With square conduct, level steps, and upright intentions ..”

Please read the thread properly before asking questions and as to why the bike is going I shall post a link in Social Chat if you are interested.

As Promised,The scuffing I mentioned is mearly cosmetic and would be on the inside when fitted so you would not see it im mentioning it because I dont want any bitching who ever buys it once you receive it.It only has one washer which I have attached to it and it fitted perfectly on my Bolt.

For whoever buys it, and this does not impact the value; the scuffing is caused by rubbing against the exhaust band. Two M10 washers between the tensioner and the engine will stop this . The rubbing mark on the inside of the forks is caused by worn pulley wheel bearings .

The How To section contains all the info you need for fitting (created after BigBri fitted his) and replacing tensioner wheel bearings.

Sorry you are de-Buelling BigBri...

_________________
08 Specialized Langster

am going to have to pass on this, just cracked my own car windscreen by accident and have to pay £300 excess to get it replaced tomorrow
good catch to whomever grabs it

edit - sent you a pm bigbri

Ok Andy so your next in line

Pm sent biggest bri

_________________
ever see a duck that couldn't swim? quack quack

Sold