Having replaced the clutch basket bearing and sprocket/5th gear bearing i have noticed a small amount of play in the mainshaft roller bearing in the trapdoor.
In the workshop manual its a transmission strip down to press the shaft out, is it possible to replace the bearing without removing all gears/counter shaft etc ?
also could someone give me the bearing number (please !)

Mainshaft is 6305 and before you ask the countershaft is 6204......both should be C3 but standard will be OK IMO. (they're ball races not rollers )

Tranny will need stripping but it's dead easy.......dont forget you'll also need 7 new snap rings

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

More parts to get, the amount of play is tiny but i might as well do them, saves problems in the near future and taking it all apart again .
I'll get there in the end.
tis a shame you dont do mail order and it costs me 30 quid in fuel to visit, have you a part number for the snap rings please ? , i will have to get em online somewhere.
Many thanks Maz your help is appreciated,

11067

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

_________________
08 Specialized Langster

Many thanks gents