It is currently 12 Dec 2024 20:50

All times are UTC




Post new topic  Reply to topic  [ 184 posts ]  Go to page Previous 13 4 5 6 713 Next
Author Message
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 18:58 
Offline
User avatar

Joined: 05 May 2009 20:00
Posts: 10978
Current ride: X1 2001
Location: southampton
OK Kev,
how about start her up
then go around , wiggling the loom, ign. switch cable ,
kill switch cables, coil high and low tension cables, basically trying to cause the fault , while stationary.

_________________
Feros Ferio


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 19:36 
Offline
User avatar

Joined: 06 May 2009 17:28
Posts: 7259
Current ride: 1991 RS1200 westwind
pash wrote:
What do the plugs look like when it konks out?


Havn't had the plugs out yet Pash..........will make sure i have a plug spanner with me next time i go for a ride ;)

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 19:38 
Is there a temp sensor on the bike? If there is would that cause it to stop running?


Top
   
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 19:40 
Offline
User avatar

Joined: 06 May 2009 17:28
Posts: 7259
Current ride: 1991 RS1200 westwind
Nutah wrote:
OK Kev,
how about start her up
then go around , wiggling the loom, ign. switch cable ,
kill switch cables, coil high and low tension cables, basically trying to cause the fault , while stationary.


Can just picture it now ...........me break dancing in the drive ......Ht lead in hand lOl lOl

Did have a wiggle about with some of the wires but bastard won't fail when you want it too lOl
I have a spare fuel tank complete with pump etc but it's been standing empty for about 6 years .....I may get some fresh petrol in it and put it on to see if it's any good.

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 19:41 
Offline
User avatar

Joined: 06 May 2009 17:28
Posts: 7259
Current ride: 1991 RS1200 westwind
losttyke wrote:
Is there a temp sensor on the bike? If there is would that cause it to stop running?


Rear cylinder temp sensor should just make it go into skip spark mode on the rear only if it thinks engine is too hot.

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 19:47 
kevmean wrote:
losttyke wrote:
Is there a temp sensor on the bike? If there is would that cause it to stop running?


Rear cylinder temp sensor should just make it go into skip spark mode on the rear only if it thinks engine is too hot.



Could that have a fault and cause it to skip spark both cylinders. If it cuts the spark out to the rear could it effect the front?


Top
   
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 20:05 
Offline
User avatar

Joined: 06 May 2009 18:18
Posts: 1512
Current ride: CB1300, Z750, R1200
Location: Esslingen/Neckar, Germany
kevmean wrote:
What should fuel pump output from ecm be?.............when i power on it is 12v but while engine was running looked to only be about 2 volts as well? does it self regulate depending on demand ?


Fuel pump output is switched to ground by the ECM, so will be 12V with pump off and should be around 0V when on.

Another question: what happens to the speedo if the engine stalls? Is it immediately dropping to 0 or does is still show the real speed while rolling?

ECM, speed sensor, BAS, injectors and coil(s) are feed by the same power supply (grey cable), so if there's a problem with power, it speed should immediately drop to zero.

_________________
"It is often said that before you die your life passes before your eyes. It is in fact true. It's called living."
Terry Pratchett


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 20:39 
Offline
proff. patpending
User avatar

Joined: 06 May 2009 20:20
Posts: 14705
Current ride: Victoria Sponge
Location: Bristol - Gateway to all things good
kevmean wrote:
losttyke wrote:
Is there a temp sensor on the bike? If there is would that cause it to stop running?


Rear cylinder temp sensor should just make it go into skip spark mode on the rear only if it thinks engine is too hot.


Let me know if you want to borrow a temp sensor to try...

_________________
08 Specialized Langster


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 20:41 
Offline
User avatar

Joined: 06 May 2009 17:28
Posts: 7259
Current ride: 1991 RS1200 westwind
gunter wrote:
kevmean wrote:
What should fuel pump output from ecm be?.............when i power on it is 12v but while engine was running looked to only be about 2 volts as well? does it self regulate depending on demand ?


Fuel pump output is switched to ground by the ECM, so will be 12V with pump off and should be around 0V when on.

Another question: what happens to the speedo if the engine stalls? Is it immediately dropping to 0 or does is still show the real speed while rolling?

ECM, speed sensor, BAS, injectors and coil(s) are feed by the same power supply (grey cable), so if there's a problem with power, it speed should immediately drop to zero.


Speedo shows real time speed after the engine cuts out .

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 20:47 
Offline
User avatar

Joined: 06 May 2009 19:47
Posts: 389
Location: Laurel's Wessex
Kev, try checking the pump connections, LHS below the tank, or, with the amount of miles you've racked up, your fuel filter, as it might be getting near it's sell by date.

Apologies if any of these have been already tried.

_________________
http://www.youtube.com/watch?v=Pbi5Ggmk ... re=related


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 20:47 
Offline
The Nagged Hubby
User avatar

Joined: 06 May 2009 21:18
Posts: 1073
A build up of water in the tank due to a bloked filler drain over time????????

Nate.


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 20:53 
Offline
I'd rather race a Honda 90

Joined: 08 May 2009 08:31
Posts: 3137
Location: Rhodesia.
Nate wrote:
A build up of water in the tank due to a bloked filler drain over time????????

Nate.


That should cause more of a misfire, but it's worth looking into, stranger things have happened.......

_________________
Spencer Racing... www.spencerracing.co.uk


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 21:01 
Offline
The Nagged Hubby
User avatar

Joined: 06 May 2009 21:18
Posts: 1073
spen wrote:
Nate wrote:
A build up of water in the tank due to a bloked filler drain over time????????

Nate.


That should cause more of a misfire, but it's worth looking into, stranger things have happened.......



Fair point Spen.

Did we do relays :? Had a Guzzi once that would just stop and another that would not crank sometimes, relays!

N.


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 22:55 
Offline
User avatar

Joined: 06 May 2009 18:24
Posts: 754
Location: Kent
kevmean wrote:
swapped relays over .....changed diodes ......clutch switch linked ........sidestand was but i had a brand new one so that is now on.......new CPS ..........just checking coil resistence


From page 1....

Hell what do I know, but I can quote stuff ;)


Top
 Post subject: Re: I Don't believe it
PostPosted: 16 Jun 2010 22:57 
Offline
I'd rather race a Honda 90

Joined: 08 May 2009 08:31
Posts: 3137
Location: Rhodesia.
Makes these look attractive......


Attachments:
honda90.jpg
honda90.jpg [ 15.11 KiB | Viewed 473 times ]

_________________
Spencer Racing... www.spencerracing.co.uk
Top
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 184 posts ]  Go to page Previous 13 4 5 6 713 Next

All times are UTC


Who is online

Users browsing this forum: No registered users and 18 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited