It is currently 16 Nov 2024 04:19

All times are UTC




Post new topic  Reply to topic  [ 93 posts ]  Go to page Previous 1 2 3 4 5 6 7 Next
Author Message
 Post subject: Re: ECM Tuning..
PostPosted: 31 May 2010 07:12 
Offline
User avatar

Joined: 17 Aug 2009 20:16
Posts: 111
Location: West Sussex
pash wrote:
Sorry, been to the Flat Track racing in South Wales on and S1 excursion to hang out with Daywalker and Toyboy1584...

Now, these are your front and rear maps.

It is the TPS 0 you need to adjust.

TBH, this is an assumption, cos I don't have an 08 bike, however the throttle is closed fully at tick over and the idle stabilisation valve takes care of things.

What you want to do is pull the fuel out, and to do this, the doctor prescribes a value of 10 from 8000 to 2400 inclusive for both maps. Save them, burn to the ECM and go and try. You need to be looking for throttle response if you were to open the throttle on the over-run to re-accelerate as well as looking to see if the popping has gone...

Let me know how you get on...


I notice the front and rear fuel maps are different in many cells..why is that? is it because of the running temperature difference?


Top
 Post subject: Re: ECM Tuning..
PostPosted: 31 May 2010 07:20 
Offline
proff. patpending
User avatar

Joined: 06 May 2009 20:20
Posts: 14705
Current ride: Victoria Sponge
Location: Bristol - Gateway to all things good
Because of the difference in volumetric efficiency between front and rear cylinders. This is governed mainly by degrees from a common datum for exhaust valve opening and individual header lengths.

_________________
08 Specialized Langster


Top
 Post subject: Re: ECM Tuning..
PostPosted: 01 Jun 2010 08:15 
Offline
User avatar

Joined: 17 Aug 2009 20:16
Posts: 111
Location: West Sussex
Pash..I Read somewhere you should reset the tps after each update?..Also should the bike be ridden at a certain rev range for the ecm to 'learn' its new programs?

Thanks for your help too.. :worthy:


Top
 Post subject: Re: ECM Tuning..
PostPosted: 01 Jun 2010 08:53 
Offline
proff. patpending
User avatar

Joined: 06 May 2009 20:20
Posts: 14705
Current ride: Victoria Sponge
Location: Bristol - Gateway to all things good
You only need to reset the TPS if you have mechanically upset the throttle butterfly / TPS sensor, or you have erased or changed the ECM's memory.

You have done neither.

To set your TPS, you open the throttle, close it, open it, close it etc. See the How To.

As for riding steady for hours on end, forget it. Go for a ride, it only takes seconds for the ECM to set the AFV once to temperature and in the closed loop learn area.

Be careful what you read ad what you believe. Loads of wives tales around.

_________________
08 Specialized Langster


Top
 Post subject: Re: ECM Tuning..
PostPosted: 01 Jun 2010 17:54 
Offline
User avatar

Joined: 17 Aug 2009 20:16
Posts: 111
Location: West Sussex
pash wrote:
Sorry, been to the Flat Track racing in South Wales on and S1 excursion to hang out with Daywalker and Toyboy1584...

Now, these are your front and rear maps.

It is the TPS 0 you need to adjust.

TBH, this is an assumption, cos I don't have an 08 bike, however the throttle is closed fully at tick over and the idle stabilisation valve takes care of things.

What you want to do is pull the fuel out, and to do this, the doctor prescribes a value of 10 from 8000 to 2400 inclusive for both maps. Save them, burn to the ECM and go and try. You need to be looking for throttle response if you were to open the throttle on the over-run to re-accelerate as well as looking to see if the popping has gone...

Let me know how you get on...


Ok fired the latest map into the ecm but something amiss..

Started bike and let it idle for a minute or so..all ok then rode off.. it misfired a couple of times and cut out..felt like fuel starvation [bike has been standing for the last month or so while I fitted new header,exhaust,filter and breather mod etc..] ..however bike restarted and after a couple of hics it ran ok..exhaust not popping but when I got back I put it on side stand and revved it a few times..it sounds as though it is 'spitting back' in the airbox when I close the throttle.. :?:


Top
 Post subject: Re: ECM Tuning..
PostPosted: 01 Jun 2010 18:14 
Offline
proff. patpending
User avatar

Joined: 06 May 2009 20:20
Posts: 14705
Current ride: Victoria Sponge
Location: Bristol - Gateway to all things good
Shouldn't do. Put the old EEPROM back in and try it.

_________________
08 Specialized Langster


Top
 Post subject: Re: ECM Tuning..
PostPosted: 12 Jun 2010 08:05 
Offline
User avatar

Joined: 17 Aug 2009 20:16
Posts: 111
Location: West Sussex
pash wrote:
Shouldn't do. Put the old EEPROM back in and try it.


Had to put things with bike on hold after a I injured my back and couldn't ride..thought it could cope with laying 80 paving slabs!!
Should be back on track soon..Im keen to get bike running as sweet as yours! :worthy:


Top
 Post subject: Re: ECM Tuning..
PostPosted: 21 Jun 2010 18:13 
Offline
User avatar

Joined: 17 Aug 2009 20:16
Posts: 111
Location: West Sussex
Philgood wrote:
pash wrote:
Sorry, been to the Flat Track racing in South Wales on and S1 excursion to hang out with Daywalker and Toyboy1584...

Now, these are your front and rear maps.

It is the TPS 0 you need to adjust.

TBH, this is an assumption, cos I don't have an 08 bike, however the throttle is closed fully at tick over and the idle stabilisation valve takes care of things.

What you want to do is pull the fuel out, and to do this, the doctor prescribes a value of 10 from 8000 to 2400 inclusive for both maps. Save them, burn to the ECM and go and try. You need to be looking for throttle response if you were to open the throttle on the over-run to re-accelerate as well as looking to see if the popping has gone...

Let me know how you get on...


Ok fired the latest map into the ecm but something amiss..

Started bike and let it idle for a minute or so..all ok then rode off.. it misfired a couple of times and cut out..felt like fuel starvation [bike has been standing for the last month or so while I fitted new header,exhaust,filter and breather mod etc..] ..however bike restarted and after a couple of hics it ran ok..exhaust not popping but when I got back I put it on side stand and revved it a few times..it sounds as though it is 'spitting back' in the airbox when I close the throttle.. :?:


Right...Hopefully back on track with tuning after fixing loose battery connection!
Have latest bin files loaded..running ok, there is a slight hesitation when opening throttle on the over-run though but no popping etc..


Top
 Post subject: Re: ECM Tuning..
PostPosted: 21 Jun 2010 20:58 
Offline
proff. patpending
User avatar

Joined: 06 May 2009 20:20
Posts: 14705
Current ride: Victoria Sponge
Location: Bristol - Gateway to all things good
Reduce the hesitation by putting a little more fuel in (check what you started out with), and you should find the happy medium between engine braking, response and popping :D

_________________
08 Specialized Langster


Top
 Post subject: Re: ECM Tuning..
PostPosted: 21 Jun 2010 22:19 
Offline
User avatar

Joined: 17 Aug 2009 20:16
Posts: 111
Location: West Sussex
pash wrote:
Reduce the hesitation by putting a little more fuel in (check what you started out with), and you should find the happy medium between engine braking, response and popping :D


Ok will add some tomorrow..I noticed my original maps show 22 between 5-8000.. below that the values increase...should we 'step up' the cell values in a similar way now or just alter all cell values from 10 to say 15??

Ta.. :sun:


Top
 Post subject: Re: ECM Tuning..
PostPosted: 22 Jun 2010 06:23 
Offline
proff. patpending
User avatar

Joined: 06 May 2009 20:20
Posts: 14705
Current ride: Victoria Sponge
Location: Bristol - Gateway to all things good
Up to you, factor them down from what they were originally if you like. I am on 10 all the way down to mid 2000s and I don't have an issue with throttle response. Might be worth putting the original map in and checking to see if it responds the same.

_________________
08 Specialized Langster


Top
 Post subject: Re: ECM Tuning..
PostPosted: 23 Jun 2010 04:23 
Offline

Joined: 13 Jul 2009 00:25
Posts: 27
Location: florida
depending on usage the Dyno showed more breaking with more fuel and less breaking with less fuel.

On my street bike I run aprox 10 to 15 and the race bike I run 40 to 50. both dont have popping 99% of the time.

Mike


Top
 Post subject: Re: ECM Tuning..
PostPosted: 23 Jun 2010 05:51 
Offline
proff. patpending
User avatar

Joined: 06 May 2009 20:20
Posts: 14705
Current ride: Victoria Sponge
Location: Bristol - Gateway to all things good
On the road I get more engine braking with less fuel. How does putting more fuel in give you more engine braking?

_________________
08 Specialized Langster


Top
 Post subject: Re: ECM Tuning..
PostPosted: 23 Jun 2010 13:56 
Offline
User avatar

Joined: 17 Aug 2009 20:16
Posts: 111
Location: West Sussex
pash wrote:
Up to you, factor them down from what they were originally if you like. I am on 10 all the way down to mid 2000s and I don't have an issue with throttle response. Might be worth putting the original map in and checking to see if it responds the same.


Ok took bike for longer ride today with original fuel maps loaded..hesitation cleared and is more responsive..occasional popping after a long decel with throttle closed but really nothing much..
Since last time I used the original fuel maps I have fitted baffles in my can as it was too noisy..maybe this has increased back pressure and contributed to less popping..

Whats best way to get that smooth tickover and low speed running ??

Cheers :sun:


Top
 Post subject: Re: ECM Tuning..
PostPosted: 28 Jun 2010 22:16 
Offline
User avatar

Joined: 17 Aug 2009 20:16
Posts: 111
Location: West Sussex
pash wrote:
Up to you, factor them down from what they were originally if you like. I am on 10 all the way down to mid 2000s and I don't have an issue with throttle response. Might be worth putting the original map in and checking to see if it responds the same.


Curious about the hesitation issue at a figure of 10 I altered the 5-8000 range cells to 15 and road tested... bike appeared respond the same as it was with original figure of 22..
All good then...!

Next..

:sun:


Top
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 93 posts ]  Go to page Previous 1 2 3 4 5 6 7 Next

All times are UTC


Who is online

Users browsing this forum: Brandwatch [Bot] and 14 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited