The Remus has a nasty crack in it near where it connects to the headers.

HD are probably responsible for this but have just told me to get fucked when I told them I'd like it replaced.

This was expected. It cost me a lot of bananas and with twins on the way I cannot afford to just skip it.

I also won't trust them to take it off/refit to the bike, so am really asking If any on you can weld and wouldn't mind giving me a hand removing/ welding/refitting. Beer tokens and I can travel a bit from base (Surrey)

Thanks

Adam is a welding instructor and Albert makes rather tasty exhausts

_________________
"With square conduct, level steps, and upright intentions ..”

Docca
I had the same, got mine welded at work, The front header stud had been stripped at some stage. I rotated the engine and drilled and tapped a fresh stud in. It has been fine since.

Mark

Ideally, go somewhere that can Tig weld. They won't charge very much. I've had a very poor experience with the welding on a Remus can that I fitted to my 1125. 'Twas fine when I did it properly

_________________
If your dreams don't scare you, they are not big enough.

That's over estimating my abilities a bit Ash. I only teach it one day a week so that I can get out of the office and get my hands dirty ..........and I only teach it to N ot V ery Q ualified Level 2

_________________
If your dreams don't scare you, they are not big enough.

you know what they say adam.
those that can do, those that can't teach

_________________
Buell X1
Buell xb12s
Buell 1125r
Ebr 1190rx
Bimota Db7
Norton v4rr??



http://www.aph-performance-engineering.com

i will do it free (well some fruit cake with iceing on top) if you get it to me.

_________________
Do you want it right or right now ?

They don't call me Birdshit for nothing .

(I did have a Coding qual. years ago though)

_________________
If your dreams don't scare you, they are not big enough.

we have a plastic pigeon we hang over the students or stupidents as we like to call them at work when they're trying to weld

_________________
Buell X1
Buell xb12s
Buell 1125r
Ebr 1190rx
Bimota Db7
Norton v4rr??



http://www.aph-performance-engineering.com

My 'students' get whipped with a thick brazing rod

_________________
If your dreams don't scare you, they are not big enough.

acetylene bomb em

_________________
Buell X1
Buell xb12s
Buell 1125r
Ebr 1190rx
Bimota Db7
Norton v4rr??



http://www.aph-performance-engineering.com

Jesus, that's brilliant.

I'll pm you.

I did it with just a plastic bag tied off with a cable tie, scared the shit out of everyone

Must put ears on next time

N.

can't beat em
we did one about half the size of a pillow with an electic cable in it, amazing,
and spud cannons too, thats what appretinceships are for

_________________
Buell X1
Buell xb12s
Buell 1125r
Ebr 1190rx
Bimota Db7
Norton v4rr??



http://www.aph-performance-engineering.com

I have just had my new metmachex swinger welded

_________________
Should Have Stuck To making Tubers