I'll be there at 9am on a black XT. White helmet (yes I know).

_________________
'08 X / '16 SX

Try wearing skimpy shorts out in the garden more often.

_________________
http://www.youtube.com/watch?v=Pbi5Ggmk ... re=related

c u there 9-15 ish....

_________________
Plan to be spontaneous, tomorrow!!

if wake up on time

_________________
Feros Ferio

I know Harleys are involved but we don't need no "Road Captains" ...........we can get lost and seperated easy enough by ourselves

_________________
I'm a Hornithologist, I get excited by exotic birds.........

what time are you setting off and do you want to meet for the trip down

What time is everyone aiming to be at the Ace for?

Probably more like 11.30, and thats assuming we don't meander too much....

_________________
Partial to a bit of both

Not sure spook... but leaving dg 20 at approx 9-30 i believe.. supposed to be meeting kev on route me thinks .. tell you a little story first... me and mrs crazy set off a day early by mistake.... so we set off 8-45 today... at 9-20 scary 85mph occurence in the fast lane of the M27... front wheel bearing popped!!!!very very dodgy 200 yds or more on a very wobbly front wheel!! .. so eventually stopped safely and RAC saw to the rest.. just got new set of bearings ,, will fit them in a mo and hopefully see you all well tommorrow... is Charlie(buzz) going?

_________________
Plan to be spontaneous, tomorrow!!

Lets get this straight; this is where we're going right?
http://www.ace-cafe-thailand.com/Beer-Prices.html

A sharp departure from DG20 at 0930 should tie in with Kev (onanist) and any more west country worzel types for 1000-1015 at B3048/3400 junction.
Hope you get your bearings sorted Col

_________________
I'm a Hornithologist, I get excited by exotic birds.........

Hope you get your bearings sorted Col [/quote]


One bearing broke up... outer steel rim jammed fuckin tight!!!!!!!!!!! . bought cold steel chissel BIG hammer etc.. cant budge it!! still trying!!

_________________
Plan to be spontaneous, tomorrow!!

If you mean the outer race is stuck in the rim ie. the rest of the bearing is missing and you have nowt to drift at.........weld a piece of flat bar across it and drift on that

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

So just to confirm, it 9.15 at DG20 for a 9.30 departure?

M az thanks for the advice.. but its all too late in the day for me now.. besides no where open and no welder at hand!! so i hope you all have a good day but afraid we wont be able to make it.. unless a miracle occurs early tommorow. so have a good day all. col..

_________________
Plan to be spontaneous, tomorrow!!

If you get somebody to run a bead of electric weld all the way around the inside of the outer bearing race (ie where the balls run) this will shrink the bearing race and it will then virtually fall out of the wheel tis a very useful trick for removing bearing remains from even a blind hole.

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.